Cayman Systems 2E-H User Manual page 84

Using the Command Line Interface
4-34
set PPP module lcp-echo-requests { on | off }
Specifies whether you want your Cayman 2E-H to send LCP echo
requests. By default, LCP echoing is turned on. You should turn off
LCP echoing if you do not want the Cayman 2E-H to drop a PPP link
to a nonresponsive peer.
set PPP module failures-max integer
Specifies the maximum number of Configure-NAK messages the PPP
module can send without having sent a Configure-ACK message. The
argument can be any number between 1 and 20. The default
integer
value for the maximum failure count is 10.
set PPP module configure-max integer
Specifies the maximum number of unacknowledged configuration
requests that your Cayman 2E-H will send. The integer argument can
be any number between 1 and 10. The default value for the
argument is 10.
set PPP module terminate-max integer
Specifies the maximum number of unacknowledged termination
requests that your Cayman 2E-H will send before terminating the PPP
link. The integer argument can be any number between 1 and 10.
The default value for the
set PPP module restart-timer integer
Specifies the number of seconds the Cayman 2E-H should wait
before retransmitting a configuration or termination request. The
integer argument can be any number between 1 and 30. The default
value for the integer argument is 3 seconds. You can reduce the
restart timer value if your link is relatively fast (28,800 bps or
greater). Conversely, you should increase the restart timer value for
slow links.
argument is 2.
integer
Cayman 2E-H User's Guide
integer
November 2000