Cayman Systems 2E-H User Manual page 49

Cayman 2E-H User's Guide
November 2000
2. Enter information about the system location in the System
Location field.
For example, you might enter the building, floor, or room
number where the Cayman 2E-H is located.
3. If you want the Cayman 2E-H to use authentication traps,
click the Authentication Traps On radio button.
If SNMP trapping is enabled, your Cayman 2E-H sends
authentication traps to all SNMP trap destinations. You must
enable trap authentication before you set up your trap
destinations.
4. Identify the SNMP communities to which the Cayman
2E-H belongs by entering a community name in the
Communities field and clicking the Add button.
By default, the Cayman 2E-H is associated with the public
community. You can associate as many as 16 communities with
the Cayman 2E-H.
5. If your Cayman 2E-H is using authentication traps,
identify the destinations to which the Cayman 2E-H
should send SNMP trap messages.
Enter the IP address of a host acting as an SNMP console in the
IP Address field.
6. Optionally, enter the name of the community for which
the trap destination is responsible in the Community field.
The optional community name identifies the name of the
Cayman 2E-H community, which is included in the trap message
the device sends to the management console. This name, which
is not used for authentication, does not have to match a
predefined community name.
7. Click the Add button.
8. Click the Save button to store your modified
configuration in the Cayman 2E-H memory.
Configuring Your Cayman 2E-H
3-29