Verifying The Default Configuration; Optional Configuration 1; Verifying Optional Configuration 1 - GE Healthcare Optima XR200amx Installation Manual

GE H
EALTHCARE
D 5336113-1EN, R
IRECTION

4.10.2.2 Verifying the default configuration

1.
2.
3.
4.

4.10.2.3 Optional configuration 1

Optional configuration 1 is to add a Tab at the end instead of Return.
This configuration sets the barcode reader to add a Tab at the end of the scan instead of a Return.
Have a printed copy of these pages on hand so you can scan the necessary barcodes. If you make
a mistake during this configuration, start over at step 1.
1.
2.
3.

4.10.2.4 Verifying optional configuration 1

1.
2.
3.
4.
10
EVISION
Turn on the system. Wait until the login screen appears.
Verify that a green LED is blinking on the barcode reader receiver.
Scan any barcode.
You will hear one set of high-low beeps. The scanned barcode characters appear in the Login
ID field on the login screen, and the cursor remains at the end of the scanned barcode.
The configuration is successful and the barcode reader is ready for use.
Replace the system covers.
Power up the system. Wait until the green LED on the receiver starts flashing.
Perform 4.10.2.1 Setting to default configuration on page
Scan the barcodes shown in
After scanning each barcode you will hear one set of high-low-high beeps. The scanner will
beep at a one-second interval, and the LED will alternate green and red.
After scanning the last barcode, the scanner beam will turn off.
SET
RZ
TAB
END
Figure 4-7 Set Tab at the end instead of Return
Turn on the system. Wait until the login screen appears.
Verify that a green LED is blinking on the barcode reader receiver.
Scan any barcode.
You will hear one set of high-low beeps. The scanned barcode characters appear in the Login
ID field on the login screen, and the cursor moves to the Password field.
The configuration is successful and the barcode reader is ready for use.
Replace the system covers.
Chapter 4 Configuration
Figure 4-7, top to bottom.
O XR200 /XR220
PTIMA AMX
I
NSTALLATION
78.
AMX
M
ANUAL
Page 79