Advertisement
<Installation of the ferrite core>
Note:
• Perform the steps only when a Fax Kit which
has a ferrite core bundled for applicable mar-
keting area is installed.
• If the telephone is not connected to the main
unit, keep the ferrite core in a safe place.
(1) Attach the supplied ferrite core to the modular
cable of the telephone.
Note:
• Install the ferrite core by winding the cable two
turns.
• Attach the ferrite core at the position same as
where a ferrite core has been attached on the
supplied modular cable.
(2) Connect the modular cable of the telephone to
the TEL port.
Note:
Connect the jack on the end near the ferrite core
to the Fax kit.
<Connecting the modular cable>
(1) Connect the supplied modular cable to the LINE
port.
Note:
• Connect the jack on the end near the ferrite
core to the Fax kit.
• Only analog circuits are allowed for users con-
necting to the Key Telephone System or private
branch exchanges (PBX).
(2) Attach the supplied clamps on the upper and
lower sides of the ferrite core(s) and secure them
at the position shown in the illustration.
<C287/C227>
Clamp
<367/287/227>
Clamp
E-6
Advertisement
