Diagnostics And Fault Clearance; Diagnostic Messages - Festo CPX-AP-A-4IOL-M12 Operating Instruction

Diagnostics and fault clearance

ID Parameter
20074 Port status information
– 0: NO_DEVICE
– 1: DEACTIVATED
– 2: PORT_DIAG
– 3: PREOPERATE
– 4: OPERATE
– 5: DI_C/Q
– 6: DO_C/Q
– 254: PORT_POWER_OFF
– 255: NOT_AVAILABLE
20075 Revision ID
20076 Transmission rate
– 0: not detected
– 1: COM1
– 2: COM2
– 3: COM3
20077 Actual cycle time [in 100 µs]
20078 Actual vendor ID
20079 Actual device ID
20080 Setpoint device ID
20108 Input data length
20109 Output data length
1) ro = read only; rw = read write
2) Changes only become effective when the port mode is changed (ID 20071).
3) Only supported in combination with IO-Link V1.1 devices.
Tab. 9: Fieldbus parameters (status/information)
9 Diagnostics and fault clearance
9.1

Diagnostic messages

Diagnostic messages of an IO-Link device are sent to the IO-Link Master via event codes. The event
code is mapped in the IO-Link master to a diagnostics ID è 9.3 Event codes.
For all diagnostic messages of the automation system as well as information on the grouping and
display of the diagnostic messages see the operating instructions for the automation system CPX-AP-I
è 1.1 Applicable documents.
The table below contains the diagnostic messages of the IO-Link master.
The table below contains the diagnostic messages of the IO-Link master.
Festo — CPX-AP-A-4IOL-M12 — 2023-01
)
Instances Data type Access
4 ENUM_ID ro
4 UINT8
4 UINT8
4 UINT16
4 UINT16
4 UINT32
4 UINT32
4 UINT8
4 UINT8
1)
Array size
–
ro –
ro –
ro –
ro –
ro –
rw –
ro –
ro –
11