Table of Contents
Advertisement
2.2.2 Lifting
Always inspect the lifting equipment and tackle before starting any work.
WARNING: Crush Hazard
Always lift the unit by its designated lifting points.
Use suitable lifting equipment and ensure that the product is properly harnessed.
Wear personal protective equipment.
Stay clear of cables and suspended loads.
NOTICE:
Never lift the unit by its cables or hose.
Lifting equipment
Lifting equipment is always required to handle the unit. The lifting equipment must fulfill the
following requirements:
• The minimum height between the lifting hook and the floor must be sufficient to lift the
unit. Contact a Xylem representative for more information.
• The lifting equipment must be able to hoist the unit straight up and down, preferably
without the need for resetting the lifting hook.
• The lifting equipment must be correctly anchored and in good condition.
• The lifting equipment must support the weight of the entire assembly. Only authorized
personnel may use the lifting equipment.
• Two sets of lifting equipment must be used to lift the unit for repair work.
• The lifting equipment must be dimensioned to lift the unit with any remaining pumped
media in it.
• The lifting equipment must not be oversized.
2.2.3 Lift and remove the pump from the transport vehicle
1. Fit a crane hook to the lifting eye on the top of the drive unit.
P7900 Installation, Operation, and Maintenance Manual
CAUTION: Crush Hazard
Improperly-dimensioned lifting equipment can lead to injury. A site-
specific risk analysis must be done.
2 Transportation and Storage
7
Advertisement
Table of Contents
