Table of Contents
Advertisement
4 Installation
b) Fit the protective rubber sleeve onto the cable where it leaves the connection
c) Attach the connection flange to the entrance flange.
6. Connect the starter equipment:
a) Connect the power cable to the starter equipment according to the diagram in
b) Connect the auxiliary cable to the starter equipment.
30
Figure 12: Cable holder
housing.
The rubber sleeve must have the correct size to give the correct compression around
the cable.
Make sure that the seal sleeve is not misaligned with the rubber sleeve. Check that
the entrance flange supports the cable so that it cannot be excessively bent.
cable phase sequence
on page 33.
P7900 Installation, Operation, and Maintenance Manual
Power
Advertisement
Table of Contents
