Cleaning; Cleaning Under The Mower Deck; Cleaning The Suspension System; Disposing Of Waste - Toro Revolution Series Operator's Manual

Hide thumbs Also See for Revolution Series:
Table of Contents

Advertisement

Cleaning

Cleaning under the Mower
Deck
Service Interval: Before each use or daily
Remove the grass buildup under the mower daily.
Important:
Do not use water to clean the
machine, otherwise you could damage the motors
and other electric components.
1.
Park the machine on a level surface, disengage
the PTO, and move the motion-control levers
outward to the P
ARK
2.
Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Turn the battery-disconnect switch to the O
position.
4.
Raise the front of the machine and use jack
stands to support the mower.
5.
Clean debris from the machine using
compressed air.
Cleaning the Suspension
System
Machines with MyRide™
Suspension System Only
Service Interval: Before each use or daily
Use compressed air to clean the suspension system.
Important:
Do not clean the shock assemblies
with pressurized water.
Figure 90

Disposing of Waste

Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
position.
FF

Storage

Cleaning and Storage

Service Interval: Before storage
Before storage
1.
Park the machine on a level surface, disengage
the PTO, and move the motion-control levers
outward to the P
2.
Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove grass clippings, dirt, and grime from
the external parts of the entire machine using
compressed air.
Important:
machine, otherwise you could damage the
motors and other electric components.
4.
Check the brake; refer to
14).
5.
Grease the machine; refer to
38).
6.
Check the tire pressure; refer to
Tire Pressure (page
7.
Check and tighten all fasteners. Repair or
replace any part that is damaged or missing.
8.
Paint all scratched or bare metal surfaces with
paint from an Authorized Service Dealer.
9.
Store the machine in a clean, dry, garage or
storage area. Remove the key from the switch
and store it in a memorable place. Cover the
machine to protect it and keep it clean.
10.
For prolonged storage, follow the battery
storage requirements; refer to
Requirements (page
g030538
52
position.
ARK
Do not use water to clean the
Park Position (page
Lubrication (page
Checking the
41).
Battery Storage
53).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z master 18740teZ master 18750teZ master 18765te

Table of Contents