Table of Contents

Advertisement

Available languages

Available languages

02. BEFORE USE

1. Using brand microSD memory cards (up to 32GB of memory) with speed class 10
is recommended.
2. Before putting the card into the camera, it needs to be formatted to FAT32 file
system on your computer, and then again in your camera.
3. The memory card should be installed when the device is turned o , otherwise you
can damage the card and the device. The same is true for taking out the memory
card.
4. Using the menu, set:
a. Date and time.
b. Loop recording (adjust the time of recording). If you turn o loop recording,
the files will not be overwritten.
c. Set the highest available resolution.
d. Set the G-Sensor to the lowest possible sensitivity so that the camera does
not protect undesired recordings because of, e.g., a bump in the road.
e. Enable HDR mode.
5. The camera has a built-in battery that allows for a short operation after
disconnecting the power supply.
6. When the memory card is full, the oldest unprotected recordings will
be overwritten.
7. It is recommended that you use the device's functions as intended. Do not use
MOTION DETECTION and PARKING MODE when driving, as it can cause the device
to turn on and o by itself. Every recording made with these modes turned on will
be protected from being overwritten.
8. It is recommended to set the G-SENSOR option to minimum to avoid protecting
unimportant files and loss of space on your memory card.
9. Sound: The device has a condenser microphone that continuously records all
of the surrounding sounds. The sounds can overlap and cause distortion.
03. DESCRIPTION OF THE RECORDER
1. Movable lens
2. Microphone (on the moving
lens cylinder)
3. Mounting location of the
handle/battery
4.Speaker (on the sides of the
holder slot)
5. POWER button
6. MicroSD memory card slot Display
7. MENU button
8. UP button
9. DOWN button
10. OK button
11. Display
12. AV port (for REAR camera connection)
13. RESET button
14. Mini USB port (power supply)
15.Mini USB port (power supply)
16. Hook
17. Multi-pin connector
18. Adhesive tape
17
EN

Advertisement

Table of Contents
loading

Table of Contents