Table of Contents
Advertisement
PCMCIA Configuration
Configuring PCMCIA Cards in Windows NT
When you have Windows NT as your operating system, the Phoenix Card Executive for
NT is automatically loaded onto your hard drive. The Card Executive configures the
PCMCIA card properly each time it is inserted in MW-520.
It is recommended to insert Ethernet cards before running Windows NT and remove the
cards after Windows shutdown. Card Executive enables Modems, ATA and SRAM cards
"hot insertion" mode, i.e., inserting and removing the cards while Windows NT are
running.
Whenever you insert a PCMCIA card in your workstation for the first time, the PCMCIA
IDE Driver Parameters appears on the screen. To configure a PCMCIA card:
1. Set the IRQ Level parameter to IRQ 11.
2. Set the I/O Port Address to Auto.
3. Press Continue.
A prompt for configuration completed appears on the screen.
PCMCIA Configuration
31
Advertisement
Table of Contents
