Image Installation Via Parallel Port; Floppy Preparation Procedure; Pcmcia Preparation Procedure; Image Installation Procedure - Motorola Mobile Workstation 520 Application Developer's Manual

Table of Contents

Advertisement

48
MW-520 Application Developer's Guide

Image Installation Via Parallel Port

Floppy Preparation Procedure

PCMCIA Preparation Procedure

Image Installation Procedure

5. Press
to "Target Drive", press
OK
6. Wait until the system image loading process is completed, then restart the
computer.
When installing an MW-520 unit system image via a parallel crossover
cable and the parallel port, it is very important that the MW-520 unit be
configured as MASTER.
Note
The MW-520 unit parallel port is by default configured for ECP. Make
sure that both the Host PC parallel port and the MW-520 unit parallel
port are both configured the same.
Note
As noted above, a bootable media is required. This can be either a bootable
PCMCIA ATA HARD DRIVE card, or a bootable floppy and a USB floppy drive.
The choice of which media to use is left to the individual administrator.
Copy Ghost.exe, and Preghost.com into the floppy.
Insert a PCMCIA ATA HARD DRIVE card into the computer:
Copy Ghost.exe and Preghost.com into the PCMCIA ATA HARD DRIVE card.
1. Ensure that the host PC (with Microsoft Windows 9x) has the GHOST.EXE
program and the MW-520 unit system image (*.img or *.gho) file.
2. Before powering-on the MW-520 unit, connect the MW-520 unit to the
Microsoft Windows 9x host via the parallel crossover cable.
3. Power-on the MW-520 unit and enter the
when the Motorola logo is displayed.
4. Open the
menu item and set the
POWER
5. Press the
key and select
F10
6. Before the MW-520 unit is restarted, either connect the USB floppy drive
(with the bootable floppy inserted), or insert the ATA HARD DRIVE card into
the MW-520 PCMCIA drive.
7. Execute the
PREGHOST.EXE
prompt. Wait until it is completed.
8. Launch the Ghost application on the MW-520 unit. Choose LPT -> Master.
9. Launch the Ghost application on the host PC. Choose LPT -> Slave.
to size and then
OK
BIOS Setup
Power Saving
to confirm changes.
Yes
utility on the MW-520 unit from the DOS
to proceed.
Yes
by pressing the
key
F2
setting to
Disabled
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

F5203F5205

Table of Contents