Table of Contents
Advertisement
Quick Links
Nady Wireless Systems are type accepted under FCC rules parts 90, 74 and 15. The
device complies with RSS-210 of Industry & Science Canada. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NADY SYSTEMS, INC.
6701 Shellmound Street • Emeryville, CA 94608 USA
Tel: 510/652-2411 • Fax: 510/652-5075
www.nady.com
VHF Wireless Microphone System
Advertisement
Table of Contents
Related Manuals for Nady Systems ENCORE I
Summary of Contents for Nady Systems ENCORE I
- Page 1 Nady Wireless Systems are type accepted under FCC rules parts 90, 74 and 15. The device complies with RSS-210 of Industry & Science Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
-
Page 2: Table Of Contents
CONTENTS CONTENTS ...2 INTRODUCTION...3 USING THIS MANUAL ...3 SYSTEM FEATURES ...4 ENCORE I RECEIVER ...5 WHT HANDHELD MICROPHONE TRANSMITTER ...8 WLT LAVALIER/LAPEL OR HEADWORN MICROPHONE BODYPACK TRANSMITTER ...10 WGT INSTRUMENT BODYPACK TRANSMITTER ...12 THE LINK 2™ PLUG-IN TRANSMITTER...14 SPECIFICATIONS ...17... -
Page 3: Introduction
This manual will first list the features of the Encore I and then will take you step by step to show you how to operate your new system. After reading the receiver instruc- tions, turn to the section of the booklet that covers the type of transmitter used with your new system. -
Page 4: Specifications
• Unique snap-out panel locking tabs for single receiver or dual receiver (side-by-side) optional rack mounting WHT HANDHELD MIC TRANSMITTER • Features the Nady DM-10D unidirectional neodymium dynamic cartridge for optimum true sound, maximum feedback rejection and minimal handling noise • OFF/STANDBY/ON switch allows convenient audio muting with the transmitter "ON"... -
Page 5: Encore I Receiver
9V Alkaline Battery 1. Rackmounting the Receiver There are 2 options available for rackmounting the Encore I receiver: singly or side- by-side with another Encore Series receiver. a. Single mounting: Remove the receiver SIDE MOUNT CLIP (1) from each side of the receiver (as shown) and slide in the optional ERM-12 RACK EARS (9). - Page 6 Connection section of the above Encore I receiver instructions. The AF LEVEL LED DISPLAY (5) on the Encore I receiver will light up to 5 LEDs (4 green and 1 red) for all input signals. Occasional flickering on and off during use of the top...
-
Page 7: The Link 2™ Plug-In Transmitter
If it does not conform or is supplied with a different connector, you must use an appropriate adapter or the lav mic may not work with the Link 2. If you have any questions, please contact your Nady dealer or Nady Systems’ Customer Service Department. -
Page 8: Wht Handheld Microphone Transmitter
Connection section of the above Encore I receiver instructions. The AF LEVEL LED DISPLAY (5) on the Encore I receiver will light up to 5 LEDs (4 green and 1 red) for all input signals. Occasional flickering on and off during use of the top red LED indicator in this display is normal, however if the red LED stays on continuously, it means the signal is too loud and there is the possibility of overload distortion. -
Page 9: Wgt Instrument Bodypack Transmitter
The AF LEVEL LED DISPLAY (5) on the Encore I receiver will light up to 5 LEDs (4 green and 1 red) for all input signals. Occasional flickering on and off during use of... -
Page 10: Wlt Lavalier/Lapel Or Headworn Microphone
Connection section of the above Encore I receiver instructions. The AF LEVEL LED DISPLAY (5) on the Encore I receiver will light up to 5 LEDs (4 green and 1 red) for all input signals. Occasional flickering on and off during use of the top red LED indicator in this display is normal, however if the red LED stays on continuously, it means the signal is too loud and there is the possibility of overload distortion.
Need help?
Do you have a question about the ENCORE I and is the answer not in the manual?
Questions and answers