Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Owner's Manual
Nady Wireless Systems are type accepted under FCC rules parts 90, 74 and 15. The
device complies with RSS-210 of Industry & Science Canada. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NADY SYSTEMS, INC.
6701 Shellmound Street • Emeryville, CA 94608 USA
Tel: 510/652-2411 • Fax: 510/652-5075
www.nady.com
Dual Receiver VHF Wireless Microphone System
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Nady Systems ENCORE DUET
Summary of Contents for Nady Systems ENCORE DUET
- Page 1 Dual Receiver VHF Wireless Microphone System Nady Wireless Systems are type accepted under FCC rules parts 90, 74 and 15. The device complies with RSS-210 of Industry & Science Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
-
Page 2: Table Of Contents
CONTENTS CONTENTS ...................2 INTRODUCTION..................3 USING THIS MANUAL ................3 SYSTEM FEATURES ................4 ENCORE DUET RECEIVER...............5 WHT HANDHELD MICROPHONE TRANSMITTER ........8 WLT LAVALIER/LAPEL OR HEADWORN MICROPHONE BODYPACK TRANSMITTER ..............10 WGT INSTRUMENT BODYPACK TRANSMITTER ........12 THE LINK 2™ PLUG-IN TRANSMITTER...........14 SPECIFICATIONS .................17 SERVICE ....................18... -
Page 3: Introduction
12V @ 400mA, nominal, Please read the instructions for your system completely before operating unit. AC/DC adapter supplied This manual will first list the features of the Encore DUET and then will take you step Antenna 11.2" (28.5 cm), dual telescopic by step to show you how to operate your new system. -
Page 4: System Features
Locking XLR jack for connecting to microphone or WHT HANDHELD MIC TRANSMITTER cable, with selectable phantom power • Features the Nady DM -10D unidirectional neodymium dynamic cartridge for Controls optimum true sound, maximum feedback rejection and minimal handling noise •WHT OFF/STANDBY/ON switch •... -
Page 5: Encore Duet Receiver
ENCORE DUET RECEIVER 1. Rackmounting the Receiver There are 2 options available for rackmounting the Encore DUET receiver: singly or side-by-side with another Encore Series receiver. a. Single mounting: Remove the receiver SIDE MOUNT CLIP (1) from each side of the receiver (as shown) and slide in the optional ERM-12 RACK EARS (9). - Page 6 5. Connecting the Audio Output 4. Microphone Operation The Encore DUET receiver provides both a fixed mic level BALANCED AUDIO OUT- Turn on the Link 2 by sliding the ON/STANDBY/OFF SWITCH (41) to the PUT XLR (14) for each channel and an adjustable line level A + B UNBALANCED STANDBY position (transmitter on, audio muted) or the ON position (transmitter AUDIO OUTPUT 1/4"...
- Page 7 If it does not conform or is supplied with a different connector, you must use an appropriate adapter or the lav mic may not work with the Link 2. If you have any questions, please contact your Nady dealer or Nady Systems’ Customer Service Department.
-
Page 8: Wht Handheld Microphone Transmitter
Connection section of the above Encore Duet receiver instructions. The AF LEVEL LED DISPLAY (5) on the Encore Duet receiver will light up to 5 LEDs (4 green and 1 red) for all input signals. Occasional flickering on and off during use of the top red LED indicator in this display is normal, however if the red LED stays on continuously, it means the signal is too loud and there is the possibility of overload distortion. - Page 9 The AF LEVEL LED DISPLAY (5) on the Encore Duet receiver will light up to 5 LEDs (4 green and 1 red) for all input signals. Occasional flickering on and off during use of...
-
Page 10: Wlt Lavalier/Lapel Or Headworn Microphone
Connection section of the above Encore Duet receiver instructions. The AF LEVEL LED DISPLAY (5) on the Encore Duet receiver will light up to 5 LEDs (4 green and 1 red) for all input signals. Occasional flickering on and off during use of the top red LED indicator in this display is normal, however if the red LED stays on continuously, it means the signal is too loud and there is the possibility of overload distortion.
Need help?
Do you have a question about the ENCORE DUET and is the answer not in the manual?
Questions and answers