Titan TTCSP49 Manual page 37

TTCSP49
4. Check the proper lubrication as described in section "Before you start - Chain
lubrication" before performing any cut.
5. Ensure the saw chain (3) is running at full speed before it makes contact with the
wood. Use the spiked bumper (16) to secure the product onto the wood before
starting to cut and use it as a leverage point while cutting (Fig. 25).
6. Reset the spiked bumper at a low point when cutting thicker logs by pulling the
product slightly backwards until the gripping teeth release, and reposition at lower
level to continue sawing. Do not remove the product completely from the wood.
7. Do not force the saw chain while cutting, let the chain do the work, using the gripping
teeth to apply minimal leverage pressure.
8. Do not operate the product with arms fully extended or attempt to saw areas which
are difficult to reach, or on a ladder. Never use the product above shoulder height
(Fig. 26).
9. Optimum sawing is achieved if the chain speed remains constant during cutting.
10. Be careful when reaching the end of the cut. The weight of the product may change
unexpectedly as it cuts free from the wood. This can cause accidents to the legs
and feet. Always remove the product from a wood cut while the product is running.
11. Check that the oil feed to the chain is operating correctly; run the chain saw at
medium speed and ensure that the chain has received a consistent coating of oil.
25
26
Operation
37