Titan TTCSP49 Manual page 20

Before you start
3. Place the slot on the guide bar (2) over the 2 bolts (step 1, Fig. 3).
4. Push the guide bar (2) to the left towards the drive sprocket (step 2, Fig. 3).
5. Place the saw chain (3) over the drive sprocket (behind the clutch) and fit around
the nose sprocket at the tip of the guide bar (2) in the correct direction (Fig. 4). Make
sure the drive links are correctly inserted in the drive sprocket and the nose sprocket.
NOTE: This symbol
runs. Fit the saw chain (3) in the correct direction (Fig. 4)
3
2
6. Pull the guide bar carefully towards the right to tighten the saw chain. Make sure
the saw chain is placed above the chain catcher (17) (Fig. 5).
5
20
1
17
indicates the direction which the saw chain (3)
4
Drive sprocket (behind the clutch)
2
TTCSP49
Nose
sprocket
2
3