Titan TTCSP49 Manual page 34

Operation
Starting the engine
DANGER! Risk of fire!
> Due to any spilled fuel, the product can catch fire.
> Wipe any spilled fuel up before starting.
> Start the engine a few metres away from the place where you have filled it.
DANGER! Risk of injury! If the chain brake is not engaged, the saw chain
starts up directly after the engine is started. Make sure the chain brake is
engaged before starting the engine!
NOTE: Risk of product damage!
Never twist the starter cord around your hand! Only pull on the handle!
Do not suddenly release the recoil starter handle! Allow the rope to return
slowly and in a controlled manner each time it is pulled!
NOTE: The break-in period! Do not use new product at full speed (full throttle
/ revolutions) for the first 2 tank fillings. All moving parts have to "bed in" during
the break-in period. The frictional resistances in the engine are greater during
the break-in period. The engine develops maximum power after about 5 to 10
fuel tank fillings.
Engine cold start
1. Place the saw where it does not come into contact with any objects.
2. Engage the chain brake (4).
3. Set the stop switch (11) to I position (Fig. 19).
4. Press the primer (21) until the bubble is filled with fuel (6 times) (Fig. 20).
5. Pull out the choke knob (7) (Fig. 21).
19
34
20
21
11
21
7
TTCSP49