Titan TTCSP49 Manual page 36

Operation
After starting the engine
1. Leave the engine running at idling speed for a while.
2. Slowly press down on the throttle trigger (10) to increase the engine speed.
The clutch will be released when the engine speed is high enough, and the saw chain (3)
will start to rotate.
3. Make sure the saw chain is sufficiently lubricated.
4. Check if the saw chain stops rotating when you release the throttle trigger (10).
Stopping the engine
1. Release the throttle trigger (10) and let the product run in idle for a while.
2. Engage the chain brake (4).
3. Set the stop switch (11) to O position.
WARNING! The product continues to work for some time even after the engine
has been stopped! Wait until it comes to a complete stop before you put the
product down!
Basic operating / cutting procedure
1. To become proficient attend a recognised chain saw training course to learn how to
operate chain saws safely and effectively. Familiarise yourself with all the controls
and switches. Practise all movements with the product switched off.
2. Always hold the product firmly with both hands. Front handle (5) with the left hand
and rear handle (9) with the right hand. Fully grip both handles at all times during
operation. Never operate the product using only one hand.
3. Only use the product with a secure stance. Hold the product at the right-hand side
of your body (Fig. 24).
36
24
TTCSP49