Preparing To Print; Starting The Printer - SINTERIT LISA X Translation Of The Original Manual

Sls 3d printer

Hide thumbs Also See for LISA X:

Table of Contents

2. Preparing to print

Connect the printer to a power source (fig. 2.1). Power

socket is located on the back of the printer.

Flip the power button on the back of the printer to the

I position.

Make sure that the E-STOP button is released. If not,

turn it clockwise as much as possible and release it.

(fig. 2.2).

After a few seconds, the main menu should appear on

the printer screen.

ATTENTION!

While preparing the printer for use, it is necessary to read and acknowledge any messages on the

screen. Disregarding or skipping any crucial steps of the process can negatively impact the quality

of printouts or damage the printer.

POWER SOCKET

POWER SWITCH (ON/OFF)

1.3 View of the back of the printer.

Fig. 2.1 Connecting the power cord to the power socket.

Fig. 2.2 Releasing the E-STOP button.

Sinterit LISA X User Manual | 5

Table of Contents

Do you have a question about the LISA X and is the answer not in the manual?