Memory Linking; Pauses - NEC DT 2000 Owner's Manual

For example, this function may be used for calling a paging system
and sending commands, ID numbers (PIN), and/or numeric messages:
(1)
"123456789" + "P" + "123456789#" + SND + SND
(1) This is the phone number to be called via the cellular system.
(2) This character indicates a Manual Pause. The user will wait for
the initial prompt from the paging system before pressing the SND
key.
(3) This a DTMF digit sequence which may represent the PIN of the
called pager.
(4) This is the initial send keypress which causes the phone to initiate
a call using the number up to the first pause mark.
(5) This is the second send keypress, while in conversation mode,
which will end the manual pause and start the sending of DTMF
digits.
PAUSES - (Automatic) [FCN + 0 + 1] This function creates pauses
while sending out DTMF signalling tones during conversation mode.
When an automatic pause is used, the phone will pause for three (3)
seconds and then continue dialing the DTMF sequence.
Multiple pauses may be placed together to extend the duration of the
pause - i.e. 6, 9, 12 seconds etc.
For example, this function may be used for calling a paging system
and sending commands, ID numbers (PIN, and/or numeric
messages:
(1)
"123456789" + "," + "," + "123456789#" + "," + "987654321#" + SND
(1) This is the phone number to be called via the cellular system.
(2) This is an Automatic Pause character which indicates a 3 second
delay.
(3) This is a second Automatic Pause character indicating a 3 second
delay. The phone will wait a total of 6 seconds before continuing with
the following DTMF digits.
(4) This is a DTMF digit sequence which may represent the PIN of
the called pager.
(5) This is an additional Automatic Pause mark. The phone will wait 3
seconds before continuing with the following DTMF digits.
(6) This is a continuation of the DTMF digit sequence which may
represent the numeric message to be sent to the pager.
(7) This is the Send keypress which causes the phone to initiate a
call.
MEMORY LINKING - [FCN + 0 + 2] Memory Linking is a
function that allows a phone number to be chained together
with a memory recall number for the purpose of adding DTMF
signalling digits after a number is to be sent.
(2) (3)
(2) (3)
(4) (5)
(4) (5)
-28-
(6) (7)