Operation Of The Phone; Placing A Call - NEC DT 2000 Owner's Manual

OPERATION OF THE PHONE

1) Press the PWR key and hold it for at least 2 seconds.
The phone will carry out a short self-test sequence, then
briefly display a default wake-up message or your wake-up
message if you have programmed one into the phone.
2) When the Signal Strength Indicator, Date and Time
Home or Roam indicator appears on the display, the phone
is ready for use.
If "No Service" appears it means that you are outside the
cellular service area and the network cannot serve you.
A cellular phone can only send and receive calls when it
is switched on, and has service (as indicated in 2 above)
3) Press the PWR key and hold it for at least 2 seconds to
switch the phone off.

PLACING A CALL

Fully extend the antenna before sending or receiving a call.
Note: Push in the antenna when you are not using the
phone.
You can use the phone without extending the antenna in a
good coverage area.
1) Key in the number (include 1 + area code if you're
making a long distance call).
Note: If you make a mistake, press the CLR key briefly to
delete the last keystroke; or press and hold the CLR key
to clear the whole display.
2) The number will appear on the display as it is keyed in.
3) Press SND.
4) The IN USE indicator will appear, and the number will
disappear from the display. The call timer will appear and start
counting upward.
5) Lift the phone to your ear, and wait until your call is
answered.
6) When you have finished the call, press END.
-8-