Keying In Names - NEC DT 2000 Owner's Manual

1) Press MEM + Memory Location Number (for example, 12
if known). If not known use # or W W W W W to find the desired memory
location.
1) Press FCN + 3. The cursor appears on the display to
indicate that the phone is in the name or character entry
mode. When you press a key, the letters listed on the key are
displayed.
2) Select the key labeled with the letter you want to display.
Press it once to enter the first letter listed on the key, twice to
enter the second letter, three times to enter the third letter,
four times to enter the key digit, and five or more times to
enter lower case letters. If you miss the desired letter,
continue to press the key until it is displayed again.
3) Select additional letters in the same way.
4) If you want to enter the same letter consecutively or enter
another letter also on the key, press the # key to advance the
cursor to the next position. You advance one space and can
now press the same key again to select the desired letter.
5) Note that you can enter up to 10 characters with any
space or symbol counted as characters. Blank spaces
can be inserted by pressing the # key; the "&", "-", "#",
and " W W W W W " symbols can be inserted by pressing the
6) If you begin your memory store procedure in the name or
character entry mode when you have finished keying in the
name, you must store this information to a vacant memory
location before you can key in the phone number. Press MEM
to recall the memory location where you stored the name. You
can then key in the phone number to store with the name.
D H B
1 2 )
1 2 3 4 5 6 7
WORK

KEYING IN NAMES

D H B
)
-15-
W W W W W key.