Preliminary Checks - Riello RESIDENCE KIS Installer And User Manual

page of 164

/ 164
Contents
Table of Contents
Bookmarks

Table of Contents

Available languages

3.23

Access to the parameters

Pressing the MENU key for at least 2 sec provides access to the P1 menu, allowing the para-

meters to be programmed.

If the menu is empty, P8.04 is displayed, otherwise the first item in the menu appears.

Access to the TECHNICAL parameters programming menu is password protected; pressing

MENU a second time for at least 2sec, PWD is displayed blinking with a frequency of 0.5sec ON

and 0.5sec OFF for 2sec.

Then <<0000>> is displayed blinking with a frequency of 0.5sec ON and 0.5sec OFF; the icons

and

come on to allow the password to be entered.

There are two levels of access to the parameters:

- INSTALLER

- SERVICE

(the user level does not require a password).

Set the password supplied by the manufacturer for the desired access level using the button at

the

arrows to enter the value.

Press the key A at the

arrow to confirm.

Pressing key B at the

arrow returns you to the previous level, exiting the P1 menu.

it is now possible to navigate the menu using the C and D arrow keys, confirming access to the

sub-menu with arrow key A or else returning to the previous level using arrow key B.

Prolonged pressure at any point of the menu (>2sec) of the

The interface also reverts automatically to the main screen if no key is pressed within 60sec.

4.1

First ignition is carried out by competent personnel from an authorised Technical Assistance

Service Riello.

Before starting up the boiler, check:

- that the data of the supply networks (electricity, water, gas) correspond to the label data

- that the extraction pipes of the flue gases and the air suction pipes are working correctly

- that conditions for regular maintenance are guaranteed if the boiler is placed inside or betwe-

- the seal of the fuel adduction system

- that the fuel flow rate corresponds to values required by the boiler

- that the fuel supply system is sized to provide the correct flow rate to the boiler, and that it has

- that the circulator rotates freely because, especially after long periods of inactivity, deposits

4.2

- Position the system's master switch to the "on" position.

If necessary, the interface automatically goes to the clock menu. On the main screen the icons

blinking with a frequency of 0.5 sec ON, 0.5 sec OFF.

To set the time and day follow the following instructions:

ƒ set the hour with the

ƒ set the minutes with the

ƒ set the day of the week with the

ƒ to exit the time programming without saving the modified values just press

NOTE: It is possible to change the TIME and DAY settings also later by accessing the P1.02

parameter in the P1 menu, or by pressing the A+C keys for at least 2sec.

key returns you to the main page.

ƒ If you need to set the language, select the menu P1 and confirm your choice using .

ƒ Use the arrows to display parameter P1.01, then enter the submenu by pressing

ƒ Use the

Each time that the boiler is powered a vent cycle is carried out lasting 4 min.

The display shows the message -AIR lighting up the icon RESET.

COMMISSIONING