Button Programming > Load > Sys > 1000S - WMF 800 Manual

9 Button Programming > Programming
9.2.7 Button Programming > Load > Sys > 1000S
10. System configuration – „Sys" – 1000S
1. Operating mode cup lighting – activates or deactivates the background lighting of the
central console (only WMF 1000proS), value must not be modified.
2. Message „Grinding degree too fine" – this value indicates when the message „Flow
stopped – grinding degree too fine" is displayed at the function „grinding degree setting"
(....max.), value must not be modified.
3. Message „Grinding degree too coarse"– this value indicates when the message „Flow
stopped – grinding degree too coarse"is displayed at the function „grinding degree set-
ting"(....min.), value must not be modified.
4. Steam cup warmer timeout – this value indicates how long (max.) the cup pre-heating
function (steam jet) can be used, value must not be modified.
5. % cup size pre-selection small – this value indicates by how many percent the cup vol-
ume is reduced for „cup small", value must not be modified.
6. % cup size pre-selection large – this value indicates by how many percent the cup vol-
ume is increased for „cup large", value must not be modified.
7. Cup pre-heater enabled – activates or deactivates the steam jet function, value must
not be modified.
8. Warm-up rinsing for Espresso – activates or deactivates the automatic warm-up rins-
ing for the 1 espresso after a longer waiting phase, value can be modified.
st
9. Short delay for double click- activates or deactivates the delay of beverage dispensing,
value must not be modified.
52