Further Functions & Setting Possibilities - Detailed Description; Hints For Easier Detection Of Functions & Setting Possibilities On The Following Pages - WMF 800 Manual

7 Further functions & setting possibilities – detailed description
7 Further functions & setting possibilities – detailed description
Chapter 7 describes with screenshots all tabs, drop-down menus as well as windows together with their functions and setting possibilities.
Partly, there is the possibility to access functions as well as setting possibilities in respectively from several tabs.
Whenever this is the case, reference is made in the index on several pages in this document.
The training documentation makes no claim to be complete; rather, its aim is to show, the „quickest"way to reach a certain result.
The screenshots of the tabs change regarding their appearance – depending on pre-setting / basic configuration etc.
Screenshots are therefore to be understood as examples. Functions and setting possibilities, which are not to be activated for the chosen examples, are grayed out
and therefore cannot be selected resp. modified for the chosen examples. However, as they are re-activated again after modification of pre-settings/basic config-
uration, the tabs are completely described anyway.
7.1 Hints for easier detection of functions & setting possibilities on the following pages
Example: You would like to modify „Current (empty bean hopper) "
Look in the subject index on the following pages for the desired term, in the a. m. example:
„Current (empty bean hopper)"
tered.
The headline on the respective page describes the path resp. the clicks how to get to this user interface in the service program - in the a.m. example
Headline: „Button Programming > Load > Sys > Parameter"
i.e. in the user interface of the service program you push first the button "Programming"; afterwards in the now opening window the buttons „Load"and „Sys"and
then you will see the tab „Parameter".
> You are referred to page 40; on the following pages it is described how and where the grinder current is to be en-
37