Advertisement
Available languages
Available languages
Installation Procedure
Before installation, check whether the draining rate of 0.6
is sufficient. 1 - Place double seal on the sealing surface and press into the retaining groove. 2 -
Position drain piece with seal under the shower tray. Guide the upper section of the double seal
through the drain hole. 3 - Screw in the fixing screws by hand. 4 - Tighten the screws evenly. Do not
use a cordless screwdriver. 5 - Insert immersion tube into the water trap. 6 - Insert sieve.
Mounting
at central drain.
1 - When mounting a central drain, the
immersion tube and plug are removed.
2 - When using a sieve, the immersion
pipe should be shortened to 1.5 cm.
3 - Insert immersion pipe. 4 - Mount
sieve.
with a 15 mm penned-up height
ENG
Advertisement
