Advertisement
Basic Operations
INSTALLATION / REMOVAL OF ARM STOPPER
When you are going to connect or disconnect cables at the rear side of the server or replace the
power unit, you need to remove the arm stopper and rotate the cable arm toward the rear side of the
server.
1.
Remove the arm stopper.
Loosen the fixing screw, and slide the arm stopper to remove it.
2.
Rotate the cable arm.
Rotate the cable arm while working with the rear side of the server.
3.
Return the cable arm.
Rotate the cable arm and store it in its original position.
4.
Mount the arm stopper.
Engage the arm stopper to the fixing screw that has been loosened in Step 1, then tighten the
screw.
This completes installation.
Arm stopper
14
Fixing screw
Advertisement
