Advertisement
Step 4: Connect cables to the server.
1.
Connect cables to the rear of the server.
IMPORTANT:
2.
Route the cables which are connected to the server with the cable ties that come with the
server.
IMPORTANT:
Route the cables and repeat ties so that they do not disturb the adjacent
servers and/or guide rails at both sides.
Give some slack on the cable between the server and the arm assembly
(SA). This is required to prevent the cable from being stressed when the
server is pulled out from the rack.
Route the cable so that the plug of the power cord is not stressed.
NOTE:
When operating the cable arm in the similar way as in Step 5, make
sure that strong tension is not applied to the cable. If the cables are strongly
stressed, give the cables some slack and route them again.
Connect cables according to the User's Guide of the server.
Cable arm
12
Repeat ties
Advertisement
