Table of Contents
Advertisement
Optional Splitwood Log Set Installation
CITY SERIES 72 - LOG INSTALLATION
Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced.
Broken logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.
*Dark brown paint is included if touch ups are required.
1
Rear Center Log
2
Rear Left Log
3
Rear Right Log
4
Left Front Log
5
Front Log (left of center)
6
Front Centre Log Piece
7
Front Right Log (right of center)
8
Front Right Log
9
Left cross log (2nd left from center)
10
Left cross log (left of center)
11
Right cross log (right of center)
12
Right cross log (2nd right from center)
13
Left cross log (far left log)
14
Right cross log (far right log)
15
Left end log
16
Right end log
Log Brackets (3)
Lava rock (purchased separately from log set)
2 lb Black Fireglass (purchased separately from log set)
Glowing wool (supplied with unit)
3/4" Crushed black glass or iceburg chips
(purchased separately from log set)
920-141
1. S hut off gas and electrical supply, allow unit to cool to room temperature.
2. Remove barrier glass (if already installed) and fi rebox glass (see manual).
3. Carefully remove the logs from the packaging and unwrap them.
The logs are fragile, handle with care—never force into position.
4. Install Black Fireglass (2lb) and glowing wool on the burner as shown below.
5. Clip on the log guides - position the rear guides by centering over the
two vertical lines on either side of the pilot hood at the back of the burner.
Install a second log guide on the 2nd vertical line right of the pilot hood.
Left log guide
Log guides installed
1
installation
CITY SERIES 72
Burner covered with Fireglass and
glowing wool
Right log guides
07.08.19
City Series CV72E-12 |
93
Advertisement
Table of Contents
