Table of Contents
Advertisement
5. Support the glass with one hand and open the 9 lower clamps.--
Lower clamps (x9) in open position
6. Pull the 3 lower glass gasket pads forward to release the glass.
7. Locate the 2 levers below the glass and turn them both 90° in a clockwise
direction to lower the firebox glass panel.
8. Carefully lean glass forward onto supports.
Gasket pad
Glass panel--leaning on supports
NOTE: The firebox glass may remain propped on the glass supports to clean
the interior surface. Use care when cleaning -- do not apply excessive force
or pressure.
9. To remove the firebox glass panel from the unit: tilt the glass forward
10. To install glass--reverse steps.
IMPORTANT: Remove glass panel completely when installing or removing
panels, logs, media, etc. to avoid causing any damage to the glass.
Push down on levers to lower glass panel
gently onto the glass supports, grip both suction clamps and lift the glass
up and out of the unit.
installation
City Series CV72E-12 |
75
Advertisement
Table of Contents
