Table of Contents
Advertisement
Follow the steps below to program the Pattern:
1. Simply press the PTRN key. (or MENU => FUNCTION =>PATTERN)
2. Select the empty Pattern number to be programmed by pushing the Joystick Up or Down.
If SEC column is not 000, then the selected No. of pattern is already recorded.
3. Press and hold down the SHFT/PGM key while controlling the camera direction and zoom
with the Joystick. Your controls will be automatically recorded until you release the
SHFT/PGM key. You can repeat this procedure until you are satisfied with the pattern
recorded.
(Or twist zoom handle or hit zoom button to start PTZ control for view selection
and hit the Focus button to stop.)
4. Scroll down to the Save and Exit option and push the Joystick to the right to save and
exit.
5. You can title the selected Pattern by twisting the Joystick. Rotate the handle clockwise
or counterclockwise to scroll through the alphanumeric characters, push the handle to right
or left to select next or previous space.
6. Pressing ESC will not save currently recorded data and exits to the previous menu mode.
Press the HOME or OFF button at any programmed position to delete the programmed
pattern.
NOTE: If total recording time reaches 240 ~ 243 seconds, it will automatically stop and go to OSD
menu.
Pattern Setup
No.
Title
01 :
xxxxxxxxxxxxxxxx
02 :
xxxxxxxxxxxxxxxx
03 :
xxxxxxxxxxxxxxxx
04 :
xxxxxxxxxxxxxxxx
TOTAL :
071
Save And Exit
20
Sec
000
041
010
020
Advertisement
Table of Contents
