Step 11 : Assigning An Ip Address - Muratec MFX-1450 Installation Manual

Step 11 : Assigning an IP Address

If your network is using DHCP
If a DHCP (Dynamic Host Configuration Protocol) server is installed on your
network, the machine will automatically be assigned an IP address and Subnet
Mask the first time the machine is turned on. According to the DHCP server
setting, a Gateway address and DNS server address may be assigned as well.
1
2
IMPORTANT
• Once the DHCP server has assigned the IP address to your machine, that IP
address MUST be reserved within the specific DHCP scope. Failure to do so
could result in failed operation when the IP address lease expires.
• After an IP address is assigned to your machine, please turn DHCP to OFF.
(For instruction, see step 1 and 2 of "IP Address," below.)
NOTE
• You can view the assigned addresses on the TCP/IP setting menu display.
• The IP address and Subnet Mask assigned from the DHCP server cannot be
modified.
• A "Gateway Address" and "DNS server address" will not be assigned if the
primary and secondary address have already been registered.
• If you are not utilizing a DHCP server, please turn DHCP to OFF and manu-
ally assign the IP address and Subnet Mask.
• If you are not installing the machine on a network, please skip to "Step 15 :
Driver installation for local printing and scanning," on page 22.
If your network is not using DHCP
You should turn off the DHCP server setting. Then enter the IP address manu-
ally to install your machine on your network.
1
 Installation Manual
Installation_Manual.indd 16
To see the assigned IP address for your machine, print the "Network set-
ting list". by pressing <Setting>  [List]  [Network Settings]  [Yes] on
the control panel.
Go to "Verifying the IP settings" on page 19 and begin with step 2.
Press <Setting> on the control panel, then [Management].
2007/04/27 12:11:40