Step 4: Please refer to following procedures to remove the
Step 5: Lightly press the button of DIN-Rail for remove it from the track.
2.2.2 Wall Mount Plate Mounting
To install the Industrial Equipment on the wall, please follows the instructions described below.
Step 1: Remove the DIN-Rail from the Industrial Equipment; loose the screws to remove the DIN-Rail.
Step 2: Place the wall mount plate on the rear panel of the Industrial Equipment.
Step 3: Check the DIN-Rail is tightly on the track.
Industrial Gigabit Ethernet Switch
-15-
User's Manual of IGT-90x
from the track.