Introduction; Modem-Based Remote Configuration Procedure - Multitech MultiDSU MTT1DSU User Manual

Data service unit

Hide thumbs Also See for MultiDSU MTT1DSU:

Table of Contents

Introduction

Remote configuration of the MultiDSU involves using modems to

communicate from the local PC or terminal to the remote MultiDSU,

where a special Remote Configuration Cable is used to link the receiv-

ing modem to the Command port of the MultiDSU.

1. At the remote site, connect a special cable (Remote Configuration

Cable) to the Command port jack on the back panel of the Mul-

tiDSU and the RS232 connector on the modem. The special cable

is a serial cable with male connectors on both ends. Refer to

Appendix A for cable details.

2. Connect the modem to your local telephone line.

3. Provide your telephone number to the person verifying your

configuration.

4. At the main site, connect your local PC to a modem that is con-

nected to a dial-up line.

5. Apply power to your terminal or PC. After the terminal or pc boots

up, run communications software. Set up your communications

software for 19.2K bps, 8N1 (8-bits, no parity, and 1-stop bit) and

call the remote modem.

6. Type "menu," then press the ENTER key to display the MultiDSU

Main Menu.

7. When done, disconnect the Remote Configuration Cable from the

modem and the MultiDSU at the remote location.

Table of Contents