Dial Command For Voice Calls +Cdv; U Packet Data Inactivity Timer +Cta - Multitech MTCBA-C-IP-N12 Reference Manual

Dial Command for Voice Calls +CDV

The numeric parameter is used to dial command for voice calls. The format of <dialstring> is identical to that
Description:
for the ATD command. This command does not cause the DCE to change to the online state.
Command syntax: AT+CDV=<dial_string>
Syntax:
Command
AT+CDV?
Note: Display the current setting.
AT+CDV=8583693450
Note: Dial for voice call.
U Packet Data Inactivity Timer +CTA
m
This command is used to Set, Read, and Test the U
Description:
Values: <val>
0
1-255
Command syntax: AT+CTA=<val>
Syntax:
Command
AT+CTA ?
Note: Display the current setting.
AT+CTA=?
Note: Display valid parameter range.
AT+CTA=1
Note: Set to one second.
Multi-Tech Systems, Inc. CDMA Wireless AT Commands (PN S000294J)
Possible Responses
ERROR
Note: Command is not valid
OK
+WORG: 8583693450
+WCNT: 3
Note: Command is valid
Traffic Channel not released during inactivity periods.
Release the Traffic Channel after <value> 1-second intervals have elapsed since last sending
or receiving RLP data frames on the U
Chapter 16 – Extended AT Commands in IS707.3
packet data inactivity timer.
m
interface.
m
Possible Responses
+CTA: 0
OK
Note: Command is valid
+CTA: (0-255)
OK
Note: Command is valid
OK
Note: Command is valid
120