Chapter 16 - Extended At Commands In Is707.3; Remote Async/Fax Command X; Reset To Default Configuration Z0; Select Tone Dialing T - Multitech MTCBA-C-IP-N12 Reference Manual

Chapter 16 – Extended AT
Commands in IS707.3
Multi-Tech CDMA modem also implements the CDMA AT commands as specified in the TIA/EIA/IS-707.3. Refer to IS707.3 for
more information about these commands (range, parameter definition, result codes, etc.).
Note: Some of the AT commands may not be supported by the network; please verify with your carrier as to its support of
IS707.3 commands.

Remote Async/Fax Command X

This command sends a CONNECT message when a connection is established by blind dialing and enables
Description:
the additional result codes.
Command syntax: ATX<n>
Syntax:
Command
ATX0
Note: Ignores dial tone and busy signal.
ATX1
Note: Disable dial tone and busy detection.
ATX2
Note: Disable busy detection & enable dial tone detection.
ATX3
Note: Enable busy detection & disable dial tone detection.
ATX4
Note: Enable busy and dial tone detection.

Reset to Default Configuration Z0

This command is used to reset to the default configuration.
Description:
Command syntax: ATZ0
Syntax:
Command
ATZ0
Note: reset to default configuration.

Select Tone Dialing T

This command is used to select tone dialing. Not relevant to CDMA data services; "T" is not sent in dial
Description:
string.
Command syntax: ATT
Syntax:
Command
ATT
Note: select tone dialing.
Multi-Tech Systems, Inc. CDMA Wireless AT Commands (PN S000294J)
Possible Responses
OK
Note: Command is valid
Possible Responses
OK
Note: Command is valid
Chapter 16 – Extended AT Commands in IS707.3
Possible Responses
OK
Note: Command is valid
OK
Note: Command is valid
OK
Note: Command is valid
OK
Note: Command is valid
OK
Note: Command is valid
107