Introduction; Overview - Fisher Scientific Isotemp 642 Installation And Operation Manual

Introduction

Section 1
This manual provides information and procedures on how to unpack, set
up, and operate the Fisher Scientific Isotemp brand of Hybridization
Incubators.
This manual is intended to be used by Fisher customers responsible for
operating the hybridization incubator.

Overview

Fisher Scientific Isotemp Hybridization Incubators are designed to process
nucleic and protein blots derived from hybridization procedures. Incubator
heat is accurately controlled to precisely maintain the chamber
temperature. Temperature can be set between slightly above ambient and
85°C and is easily set by simple controls on the front panel. A large, bright
display shows actual temperature during operation. The incubator features
keypad protection, which prevents the set temperature from being
changed. This is useful when setting up a processing program where the
unit will be unattended.
An offset temperature can be programmed to compensate for the actual
temperature inside a typical sample loaded into the tubes. The incubator
can monitor and store the maximum deviation of the actual temperature
from the set temperature. Temperature deviation can be monitored and
saved during processing and recalled later. A separate safety thermostat
limits the incubator temperature to approximately 95°C in the event of a
temperature controller failure. An indicator on the front panel shows when
this condition exists.
A rotisserie holds the sample tubes and rotates to provide membrane
coverage. Rotisserie rotation speed can be varied by a knob on the front
panel. A jog control permits rotating the rotisserie in steps to insert and
remove tubes.
The incubator has a glass door for observing samples during processing.
Interior surfaces are stainless steel for high durability and low maintenance.
Small and medium same size units are stackable with an optional stacking
plate. The small incubator can be mounted under a cabinet or counter
with the optional mounting bracket.
Fisher Scientific Hybridization Incubators 1-1