Starting/Ending Standby; Preparing The Mr System; Connecting The Squeeze Bulb And The Headset; Setting Tunnel Conditions - Siemens MAGNETOM Avanto Operator's Manual

MAGNETOM Avanto, MAGNETOM Verio | syngo MR E11
Print No. MR-01501G.621.02.02.02

In case of problems during shutting down, see troubleshooting
information:
Off))
5.2.4

Starting/ending Standby

Standby can be switched on by using the System Manager in the
syngo MR software. See:
1 Select System > Control to open the System Manager.
2 To start Standby: On the Meas & Recon tab, click the Standby
button.
The System Manager - Scanner StandBy dialog box opens.
3 To end Standby: At the alarm box, press the SYSTEM ON button.
5.3

Preparing the MR system

The holder for infusion bottles can be attached to the magnet cover
to the left above the patient table.
5.3.1

Connecting the squeeze bulb and the headset

(1) Connection for headphones
(2) Connection for squeeze bulb
1 Connect the hose connector of the squeeze bulb to the
corresponding connector at the foot end of the patient table.
2 Connect the headset to the corresponding connector at the foot
end of the patient table.

Setting tunnel conditions

5.3.2
Use the switches at the control unit to set the conditions in the
magnet tunnel.
MR system operation
( Page 108 Shutting down the system (System
Software operator manual
5
111