Parameters Of The Module - Siemens SIMATIC ET 200SP HA Equipment Manual

Parameters/address space
5.2 Description of parameters
Cross-channel parameters act on all identically named parameters of the channels of the module
and thus allow a higher-level setting.
Note
Due to dependencies, the parameters of the channels can be reset to default values if cross-
channel parameters are changed.
Therefore, check the setting of the channel parameters after changing a cross-channel
parameter.
The function of the cross-channel parameters is identical to the parameters of the channels.
• "Channel activated"
• "Diagnostics: Wire break"
• "Input delay (ms)"
• "Pulse stretching (s)"
• "Flutter monitoring"
• "Number of signal changes"
• "Monitoring window (s)"
• "Sensor supply"
• "Short-circuit test"
• "Time for short-circuit test (ms)"
• "Startup time of sensor after short-circuit test (ms)"
You can find detailed information on this in section "Parameters of the channels (Page 29)".
5.2.3

Parameters of the module

Diagnostics missing supply voltage L+
Enabling of the diagnostics for missing or insufficient supply voltage L+.
By default, this parameter is "Activated", cannot be changed and is only used for display.
Behavior after channel fault
With this parameter you specify whether the entire F-module is passivated after channel faults
or just the faulty channel(s):
• "Passivate entire module"
• "Passivate channel"
26
Equipment Manual, 08/2021, A5E45647528-AD
F-DI 16x24VDC HA