Error Indicators - Epson DS-80W User Manual

User's Guide

Error Indicators

Scanner errors
Indicators
Battery charging errors
Indicators
Network connection errors
Indicators
Scanner Basics
Situation
A paper jam has occurred.
A fatal error has occurred.
The firmware update failed.
The scanner has started in recovery
mode.
Situation
Battery charging has been stopped be-
cause it became too hot.
Battery charging has stopped because
it is too cold.
The battery cannot be fully charged
even if you are charging the battery
within the guaranteed charging tem-
perature range (8 to 35 °C (46 to 95
°F)). It may be damaged or has reached
the end of its service life.
Situation
An access point settings error has oc-
curred.
and light flash at the same
time.
13
Solutions
Remove jammed original, and then
load the original again.
Turn the power off and on again. If the
error continues to occur, contact your
local dealer.
Follow the steps below to try to up-
date the firmware again.
1. Connect the computer and the scan-
ner with a USB cable. (During recovery
mode, you cannot update the firm-
ware over a network connection.)
2. Visit your local Epson website for fur-
ther instructions.
Solutions
Charge the battery in an ambient tem-
perature of 8°C to 35°C (46 to 95 °F).
Contact your local dealer.
Solutions
Restart the scanner and access point,
move them closer together, and then
make network settings again.