Table of Contents
Advertisement
LS2200
•
user configurable performance controls
- scanning speed (Half/Full)
- code density optimization (High/Standard)
- scanner power (On/Off)
The laser beam output window is on the side of the scanner (Figure A,
A security system allows the laser to activate only once the motor has
reached the correct rotational speed; consequently, the laser beam is
generated after a slight delay from the power on of the scanner.
1.2.1 Indicators
The four LEDs on the scanner indicate the following:
POWER ON
GOOD READ
LASER ON
HI-RES
The screw holes on the body of the reader are for mechanical fixture (Figure
A,
).
8
2 - General Features
(red). Indicates the reader is connected to the power supply.
(Figure A,
).
3
(red). Is used to signal the possibility of a successful
barcode reading. (Figure A,
(green). Indicates laser ON state. (Figure A,
(green). Indicates when high density code optimization is
enabled by the decoder (Figure A,
).
4
).
6
DATALOGIC
).
2
).
5
Advertisement
Table of Contents
