Hilti FX 3-A Operating Instructions Manual page 32

Hilti charger
1.2.3 Symbols in illustrations
The following symbols are used in illustrations:
These numbers refer to the illustrations at the beginning of these operating instructions.
The numbering reflects the sequence of operations shown in the illustrations and may deviate
from the steps described in the text.
Item reference numbers are used in the overview illustration and refer to the numbers used in
the key in the product overview section.
This symbol is intended to draw your special attention to certain points for handling the product.
1.3 Product-dependent symbols
1.3.1 General symbols
Symbols used in relation to the product.
The power tool supports near-field communication (NFC) technology, which is compatible with
iOS and Android platforms.
Direct current (DC)
General warning symbol
1.3.2 Obligation symbols
Mandatory actions
Read the operating instructions
Wear protective gloves
Wear hearing protection
Wear eye protection
1.3.3 Warning signs
Hazard warning
Warning: Non-ionizing radiation
Warning: Magnetic field
Warning: Electric voltage
Warning: Flammable substances
Warning: hot surface
1.4 Product information
Hilti products are designed for professional use and may be operated, serviced and maintained only by
trained, authorized personnel. This personnel must be specifically informed about the possible hazards. The
product and its ancillary equipment can present hazards if used incorrectly by untrained personnel or if used
not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
22 English 2302408
*2302408*