Aston Martin DB11 Owner's Handbook Manual page 260

Wheel Bolt Torque
Caution: You must use an applicable plastic-sleeved
socket to remove, install, and tighten the wheel bolts. This
will help to prevent damage to the surface of the wheel.
All wheel bolts must be tightened in two stages:
• Tighten every second wheel bolt (in the order shown) to 70
Nm (52 lb/ft) until all five bolts are tightened.
If a locking wheel bolt is installed, this should be installed last.
• Tighten every second wheel bolt (in the order shown) to 150
Nm (111 lb/ft) until all five bolts are tightened.
12.58
Maintenance and Technical Data
Tire Repair Kit
Warning: Do not use the system to seal a tire that was
damaged while driving with insufficient air pressure (e.g. tire
cuts, cracks, bumps or similar damage). Do not use the
system to seal tyres with side wall damage. Only punctures in
the tread area of tyres may be sealed.
Warning: Do not stand directly beside the tire while the
compressor is pumping. Watch the side wall of the tire. If
there are any cracks, bumps or similar damage set the
compressor to OFF. The journey should not be continued.
Contact your nearest Aston Martin Dealer.
Warning: If a tire pressure of 1.8 bar (26 Psi) cannot be
reached then the tire can not be sealed. Do not attempt to
re-inflate the tire. Contact your Aston Martin Dealer.
Warning: If the pressure in the tire after driving for 3 km
is below 1.3 bar (19 Psi) the tire has not been effectively
sealed. The journey should not be continued. Contact your
nearest Aston Martin Dealer.
Warning: After a longer period of rest, the tire pressure
should be rechecked.