Advertisement
Quick Links
IMPORTANT
Carefully remove all the parts from the carton and
place them individually on a soft cloth to prevent
scratches or other damage.
Carefully and strictly follow these assembly instructions
to ensure a completed product as designed.
Do not use power tools above 8 volts to assemble.
Part List
A.
Top
1 pc.
B.
Shelf
4 pcs.
C.
Shelf
1 pc.
D.
Base
1 pc.
Hardware List
Hex Wrench
1 pc.
Small Hex Wrench
1 pc.
Tool(s) required for assembly: Phillips screwdriver, Level, Drill (8 volts or less), 3/8" Drill Bit
home
5053-102
Seven Tier Shelf
E.
Side Frame
1 pc.
styles Customer Service: www.homestylesfurniture.com,
servicedesk@homestylesfurniture.com,
F.
Side Frame
1 pc.
I.
Stretcher
3 pcs.
M6x16
Head Cap Bolt
30 pcs. (+1 extra)
Flat Washer
20 pcs. (+1 extra)
888-680-7460
G.
H.
Side Frame
Side Frame
1 pc.
1 pc.
J.
Stretcher
1 pc.
Spring Washer
30 pcs. (+1 extra)
Flat Washer (large)
Adjustable Pin
10 pcs. (+1 extra)
16 pcs. (+1 extra)
Advertisement
Related Manuals for Homestyles 5053-102
Summary of Contents for Homestyles 5053-102
- Page 1 5053-102 Seven Tier Shelf IMPORTANT Carefully remove all the parts from the carton and place them individually on a soft cloth to prevent scratches or other damage. Carefully and strictly follow these assembly instructions to ensure a completed product as designed.
- Page 2 Assembly Instructions 2/5 IMPORTANT Ÿ Use a soft cloth between these parts and the floor. Ÿ Do not use power tools above 8 volts to assemble. Ÿ Do not tighten all the bolts until each part is properly assembled. Ÿ The unit must be level to work properly.
- Page 3 Assembly Instructions 3/5 STEP 3 Attach unit to unit from Step 1 with Flat Washers, Spring Washers and Head Cap Bolts, tightening bolts only halfway. Tighten all bolts used in Steps 1, 2 and 3. Flat Washer (large) Spring Washer Head Cap Bolt STEP 4 Attach Top (A), Shelf (C) and Base (D) with Flat Washers (large), Spring Washers and...
- Page 4 Assembly Instructions / 4 5 Adjustable Pin Figure 2 STEP 5 Figure 3 Turn unit to its upright position. Insert Adjustable Pins into unit at desired level. (See Figure 2) Place Shelves (B) into position. Level unit by adjusting the adjustable levelers on bottom of unit. (See Figure 3) Note: Unit must be level to work property.
-
Page 5: Hardware List
Assembly Instructions / 5 5 IMPORTANT Ÿ To help reduce the risk of the unit tipping over, the Tipover Restraint must be installed following these instructions exactly. STEP 6 Anchor in wall Wall Screw Pre-drilled hole Bracket on wall at top of unit Place unit at desired location. - Page 6 CARE INSTRUCTIONS NEVER NEVER use glass cleaners on allow liquids to remain on furniture. finished furniture. Ammonia Absorption causes parts to warp chemically attacks the finish. and split and finishes to delaminate. Do not use power tools Do not place Do not write above 8 volts to assemble.