Table of Contents
Advertisement
Establishing a Console Connection
The serial console may be needed for part of the initial fabric module setup, for troubleshooting, or for general fabric
module management using Linux and the CLI. For serial access, the console system must be connected to the console port
on the fabric module. To connect to the serial console port, use the following settings:
•
115.2 Kbps
•
8 data bits
•
1 stop bit
•
No Parity
Establishing a Management Network Connection using an IPV6 Link-Local Address
For an IPV6 link-local connection, you SSH into the fabric module through the network that is connected to the fabric
module's management port. The IP address of the fabric module is determined by its MAC address, which you can convert
into a link-local address using any of the available online tools.
The fabric module MAC address is located either on the label attached to the top of the fabric module or on a pull tab
located under the management panel on the back (power side) of the fabric module.
The IPV6 link-local syntax is as follows:
username@ipv6-address + percent sign (%) + interface-id
where:
ipv6-address Destination fabric module address
interface-id Source output interface ID
Example:
ssh admin@fe80::216:eaff:fe5f:4cad%eth0
Powering the FM 2072 Up or Down
There is no power switch on the FM 2072.
Powering Up
When you connect one or both power supplies and provide site power to the fabric module, it automatically powers up.
NOTE: There are two power supplies that should be connected to separate site power sources for redundancy.
17
Installing HPE FM 2072
Advertisement
Table of Contents
