Connecting Fabric Ports To An Fm 1006; Fm 1006 Composable Fabric Example - HP HPE FM 2072 Installation Manual

Connecting Fabric Ports to an FM 1006

To connect a fabric module to an FM 1006, use two breakout (see Figure 2: FM1006 Fabric Interconnect Cable). The 3-
connector side of the cable plugs into the three upper or lower highest-numbered fabric module QSFP+ ports.
For example:
Breakout Cable
1
2
The FM 2072 Fabric ports are shown here:

FM 1006 Composable Fabric Example

The following illustration shows a network topology that connects the Composable Fabric across two racks using four
fabric modules (in this example, FM 3180 modules) connected through an FM 1006 passive interconnect module.
from FM 1006 port . . .
Upper (red) port (example, E1)
Lower (blue) port (example, W1)
Creating a Composable Fabric Using FM 1006 Passive Interconnect Modules
fan out to FM 2072 ports . . .
Cable connector #1 to port 49
Cable connector #2 to port 51
Cable connector #3 to port 53
Cable connector #1 to port 50
Cable connector #2 to port 52
Cable connector #3 to port 54
23