Charging Of Battery When Boat Not In Water; Service, Repair, And Disposal Of High-Voltage Battery; Reset A Fuse Or Circuit Breaker - X SHORE EELEX 8000 Owner's Manual

5. Reinstall the pumps.
6. In the aft hatch, open the valve by turning the lever parallell to the tubing.
7. Make sure the hatches are closed properly.

Charging of battery when boat not in water

When the boat is out of the water, charge the high-voltage lithium-ion batteries using low current (maximum 10 A). The
on-board charger is cooled using seawater. With no seawater available, there is a risk of overheating if higher current is
used.

Service, repair, and disposal of high-voltage battery

WARNING
• The voltage in the high-voltage network and the high-voltage batteries is life-threatening. The system can be
active even if the ignition is switched off.
• Do not touch damaged high-voltage components or high-voltage cables. High-voltage components are labeled
with yellow safety labels. All high-voltage cables are orange.
In case of damage to a high-voltage lithium-ion battery, contact our Technical Support immediately. The battery has a
built-in control system that detects critical errors. If a critical error is detected the control system will, after a defined
delay, prevent the battery from delivering power.
In the event of damage or disposal of the battery, you are obliged to return the battery to X Shore or to contract a
qualified specialist company to dismantle, recycle and dispose of the battery. Only qualified and trained persons are
allowed to work on a high-voltage system and systems which are directly or indirectly influenced by it. See Safe handling
of high-voltage battery system, page 56.
Special regulations apply to damaged lithium-ion batteries. For further information please contact our Technical Support.
For detailed information please contact a hazardous goods safety adviser.

Reset a fuse or circuit breaker

WARNING
Before connecting an electric circuit, make sure the circuit is not damaged. A short circuit may cause a fire.
71