Clean The Cover; Inspection By A Qualified Technician Every Six Months - X SHORE EELEX 8000 Owner's Manual

1. Wash the boat with freshwater.
2. Polish the stainless and chromed parts with chrome polish.
3. Clean the aluminium parts with fresh water. If necessary, us a soap solution.
4. For a teak deck: clean with fresh water. If necessary, us a soap solution.
Over time, the teak deck takes on a satin grey appearance.
5. For a cork deck: clean with fresh water. If necessary, us a soap solution. Stubborn stains can usually be removed with
fine sandpaper (40 grit or 80 grit).
6. Rinse the cover in fresh water. Allow to dry thoroughly before folding away.

Clean the cover

The cover should be thoroughly cleaned two or three times a year.
1. Let the fabric cover soak in water for at least 24 hours.
2. Wash both sides of the cover with a sponge or soft brush. Use plenty of mild soapy water with a temperature of
maximum 30 °C.
3. Rinse thoroughly with freshwater. To neutralize the soap residues, add 12 % vinegar to the final rinsing water.
4. Hang the cover to drip dry.

Inspection by a qualified technician every six months

Every six months, hire a qualified technician to do the following.
•
Check that the wiring connections and the housing of each high-voltage lithium-ion battery are intact. If damaged,
contact our Technical Support.
•
Check the mounting points for integrity and safe grip. Repair defective mounting points. If damaged, contact our
Technical Support.
•
Check the connections of the fluid circuit interfaces for tightness. Tighten loose lock nuts with a torque of 45 Nm.
•
Check the magnetic filter for contamination. If dirty, clean with an air jet.
•
Check the degassing unit for contamination. Remove any dirt with a clean and dry cloth.
65