Canvac Q Air CFK3301V Use Instructions page 8

8
GB
Press once to turn on UV sterilization; the display will show "U". Press again to
turn off UV sterilization. UV sterilization will automatically shut down after 1 hour.
Press the Cool mode button to enter Cool mode. You can adjust the airflow in
this mode. Note: Cool mode is the default mode when the appliance is turned on.
Press the + button on the left side of the remote control to increase the air-
flow; press the - button on the left side of the remote control to decrease the
airflow. There are 9 airflow settings in Cool mode and 4 airflow settings in Warm
mode.
Press the Warm mode button to enter Warm mode. The digital display will
show the ambient temperature. You can adjust the airflow and temperature in this
mode. Turbo mode / Sleep mode are not available in Warm mode.
In Warm mode, press the temperature button on the right side of the remote
control to set the temperature (1–30°C).
Note: this button does not work in Cool mode.
Press the timer button on the remote control to set the timer between 1 to 8
hours. A small "." will flash in the lower right corner of the digital display to indicate
that the timer has been set.
Warning
Issues that may occur due to the overlap of frequencies of remote controls are
listed below.
1. This bladeless heater may react when you use a remote device for other
appliances.
2. When using the remote control of this bladeless heater, other electrical
appliances may react.
The switch on the remote will turn this fan to standby, but will not
turn it off completely. Use the ON/OFF switch on the body of the
fan to turn it off when not in use.
If the fan will not be used for a long time, please unplug the power
cord.
© 2022, Elon Group AB. All rights reserved.