Error Messages (General) - ACU-RITE 100S Reference Manual

Error Messages (General)

When is powered up, it will run a series of tests to ensure that the
100S
software is working properly. If an error message appears, refer to the
charts on this page and the next for a diagnosis and solution.
A power loss has occurred. This message will appear
E1
every time you power up the system and can be cleared
by pressing the
at any time other than at power up, a power interruption
has occurred and your current table position may be
lost. Re-establish the datum if necessary. If the problem
persists, contact your distributor for repair/replacement
procedures.
An EEPROM memory error has occurred. Press the
E2
CLEAR
setup information may be lost. These areas should be
checked and reestablished upon power up. If the problem
persists, contact your distributor for repair/replacement
procedures.
A ROM memory error has occurred. Press the
E3
key to acknowledge the error. If the system does not
operate properly, contact your
repair/replacement procedures.
A random access memory (RAM) error has occurred.
E4
Press the
tinue with the next test. If the system does not
operate properly, contact your
repair/replacement procedures.
A scale miscount error (invalid waveform) error has
E9
occurred. The E9 message will appear on the axis that
has the error. Press
current position may be lost. Re-establish the datum if
necessary. If the system does not operate properly, con-
tact your
dures.
Reference Manual
100S
TROUBLESHOOTING
key. If the E1 message appears
CLEAR
key to acknowledge the error. The datum and
key to acknowledge the error and con-
CLEAR
CLEAR
distributor for repair/replacement proce-
100S
CLEAR
distributor for
100S
distributor for
100S
to reset the axis(es). Your
31