ACU-RITE 100S Reference Manual page 27

OPERATION
6. Press the key. Enter the bolthole pattern's center point on the Y-axis.
Y
Use a decimal point and minus (-) sign if necessary.
7. Press the
ENTER
8. Press the
ENTER
9. Enter the radius of the circle pattern. Press
.
ENTER
10. Press again. "START" will appear on
ENTER
the X-axis display.
11. Enter the start angle of the first hole in
the bolthole pattern. (0 degrees is at the
3 o'clock position.) Use a decimal
point and minus (-) sign if necessary.
12. Press to complete the pattern.
ENTER
24
key.
key again. "Radius" will appear.
Reference Manual
100S